Two wires go to the brake light switch. If I remember correctly, it doesn't
matter which way they go.
Paul
In a message dated 6/6/2004 1:14:51 PM Eastern Daylight Time,
daveford1@xxxxxxxxxxx writes:
>
>
> My brake lights do not work on a 58 I recently acquired.. I found a wire
> disconnected at the bottom of the master cylinder sensor/pressure switch.
> There is another wire that is bundled with the one that I connected that
> doesn't have a connector. The one that I connected had a female connector
> so it was obvious where it went.. Is there two wires that go to that sensor?
> I have a hard time seeing because it's under the PB bellows...
>
> Thanks,
> Dave
>
> _________________________________________________________________
> Get fast, reliable Internet access with MSN 9 Dial-up � now 3 months FREE!
> http://join.msn.click-url.com/go/onm00200361ave/direct/01/
>
>
>
Back to the Home of the Forward Look Network