distributor wiggle

[RandalPark@xxxxxxx]

Years ago the distributor in my '56 Imperial became so worn that the rotor 
scrapped the inside of the distributor cap. It rained little flakes of brass 
down over the points, which finally must have arced and killed the ignition. 
When it quit, one of the first things that I did was open the distributor and 
discover that problem. Once I replaced it, the car started and ran fine.

Paul

In a message dated 8/8/2004 12:45:34 PM Eastern Daylight Time, "Dick Benjamin" 
<dickb@xxxxxxxxx> writes:

>The rotor is on a shaft which is free to rotate a small amount as the
>centrifugal advance weights swing out at higher RPMS. �If you take out the
>breaker plate and look, you can see this mechanism. �There should be two fly
>weights, held in by a couple of springs, and a cam mechanism to advance the
>rotor shaft when the weights are extended. � If you are remarking about the
>ability to rotate the rotor, and if it returns to the same point every time
>when you release it, there is no problem, relax.
>
>If, on the other hand, you can make it stay rotated when you advance it,
>your advance mechanism needs service.
>
>Lastly, If you are talking about being able to move the rotor sideways (not
>in pure rotation), you've got a badly worn out distributor - I'm amazed the
>car will run that way. �The top bearings are totally shot!
>
>Dick Benjamin.
>
>-----Original Message-----
>From: mailing-list-owner@xxxxxxxxxxxxxxxx
>[mailto:mailing-list-owner@xxxxxxxxxxxxxxxx] On Behalf Of johan C wildhagen
>Sent: Sunday, August 08, 2004 6:56 AM
>To: mailing-list@xxxxxxxxxxxxxxxx
>Subject: IML: distributor wiggle
>
>My distributor rotor always wiggled left and right about a quarter of an 
>inch. Is this normal?
>
>Johan
>Washington DC
>65 LeBaron 413
>
>
>
>
>----------------- �http://www.imperialclub.com �-----------------
>This message was sent to you by the Imperial Mailing List. Please 
>reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
>shared with everyone. Private messages (and attachments) for the
>Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
>To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>
>
>
>
>
>
>----------------- �http://www.imperialclub.com �-----------------
>This message was sent to you by the Imperial Mailing List. Please 
>reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
>shared with everyone. Private messages (and attachments) for the
>Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
>To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
>
>